Implementation 2 - Out-of-the-box CYMDIST/Electric Solver

This is the out-of-the-box implementation for CYMDIST and SynerGEE. It requires that your data fit the Minerville data model. Feeder information is exported out of the geodatabase, converted to the format expected by the Vendor API, then imported into your engineering analysis engine.

All features and attributes in the Minerville data model may be imported into the analysis engine.
The out-of-the-box implementation requires little (if any) custom code.
This implementation is available only if your data fits the Minerville data model.
Load case data is exported from the geodatabase to the NetworkAdapter.mdb where it can be edited before going to your analysis engine.

This implementation requires that you populate the load case tables (Transformer_Load_CYMDIST or Transformer_Load_ElecSolver) with data from your CIS. Load data is sent to your engineering analysis engine (via NetworkAdapter.mdb) when the user clicks the Get Load Case button on the Network Adapter toolbar (see Using Network Adapter online help). Analysis results are stored in the NetworkAdapter.mdb and may be viewed in ArcMap using joins.

To implement Implementation 2 with CYMDIST or SynerGEE, perform the following implementation steps. For this implementation, your data format must match the Minerville data model.

Configure Geodatabase
Equipment ID
- Modify Format for CYMDIST
- Modify Format for SynerGEE
Load Data
- CYMDIST Supported Attributes
- SynerGEE Supported Attributes
View Results in ArcMap
- Create Joins
- Assign Label Expressions

Note about SynerGEE: SynerGEE does not support more than one device of the same type on the same edge. To place multiple devices of the same time on a single conductor, the conductor feature must be split.